dfcecf1eb2
When both `Fn` keys are `KeymapNext_Momentary`, holding both would get us to the `NUMPAD` layer, which overrides the palm keys and turns them into `Keymap1_Momentary` keys. Thus, when releasing them, we would receive a release event for `Keymap1_Momentary`, not for `KeymapNext_Momentary`, and we'd be stuck on the `Numpad` layer until toggling it off. To avoid this scenario, change the `KeymapNext_Momentary` keys into `Keymap1_Momentary`, so we never reach the `NUMPAD` layer via the `Fn` keys. Fixes keyboardio/Kaleidoscope#151, with thanks to @chughes87 for the report! Signed-off-by: Gergely Nagy <algernon@madhouse-project.org>
Kaleidoscope
Flexible firmware for Arduino-powered keyboards
Getting Started
Pick a directory to work in, you'll need to clone multiple repositories. We'll assume you picked $HOME/kaleidoscope, if you chose another adapt the commands below accordingly.
Setup the Arduino IDE
Setup the Arduino IDE on your system. Make sure you install at least version 1.6, since older version may not support all required features.
- On Linux, follow the instructions on the wiki.
- On macOS, install using homebrew cask with
brew cask install arduinoor download the application from the official website and move it to your/Applicationsfolder.
Install the Kaleidoscope Hardware Definitions
# you'll need to know your arduino sketchbook directory
# on macOS the default is
SKETCHBOOK_DIR=$HOME/Documents/Arduino
# on Linux the default is
SKETCHBOOK_DIR=$HOME/Arduino
# make a directory for kaleidoscope, the Model 01 firmware
mkdir $HOME/kaleidoscope
# go to your kaleidoscope directory
cd $HOME/kaleidoscope
# then clone the hardware definitions
git clone --recursive https://github.com/keyboardio/Arduino-Boards.git
# and make them available to the arduino environment
mkdir -p $SKETCHBOOK_DIR/hardware/keyboardio
ln -s $HOME/kaleidoscope/Arduino-Boards $SKETCHBOOK_DIR/hardware/keyboardio/avr
Clone and Build the Kaleidoscope Firmware for the Model 01
# go to your keyboardio directory
cd $HOME/kaleidoscope
# then clone the firmware repository
git clone https://github.com/keyboardio/Model01-Firmware.git
# and build your firmware!
cd Model01-Firmware
make flash
# When the builder tells you to hit return to continue,
# hold down "prog" on your keyboard and hit return.
<3 jesse
